2 Thumb Grip Fitting Instructions

Fitting Your 2 Thumb Putter Grip
		1 - Secure club in vice below grip. Using utility knife, remove off grip and tape. Clean shaft with solvent. (White spirit or similar)

		2 - Apply double-sided tape, leave 1/4" overhang at butt end. Smooth and remove backing. Tuck in overhang.

		3 - Apply solvent generously over tape. Squirt liberally inside grip. Shake to distribute.

		4 - Pour excess solvent from grip over entire taped surface.

		5 - Align grip with clubface. Push grip quickly on shaft unti fully seated against shaft end.

		6 - Remove from vice. Make final alignment adjustments. Wipe clean. Allow to dry for 24 Hours.